Slip Sliding Away

With Jeff laid off and me having a home daycare, we can't always do what we'd like to on a nice hot day.  The nearest water park is almost 2 hours away and not my cup of tea.  The beach is about 15 minutes but we don't always have room in the van.  Out of desperation for summer fun that is cheap and can be done in our back yard, I've come up with a few water activities that are relatively inexpensive and easy to do.

Four years ago we made a slip and slide with a sheet of plastic.  That summer I was very, very pregnant and not up to lugging kids to the beach.  We also went about three weeks without a vehicle. ( It's an amusing story)  Then Lydia arrived and I wasn't taking a newborn to the beach.

This year I improved on the design of the slip and slide and hopefully we'll make it last the whole summer.  Here's how to make your own backyard waterpark.

Materials: 

• a roll of vapour barrier $29.99 at Home Depot and I have enough for about 4 slides


• 10 plastic tent pegs - we found them at the dollar store


• 9 tennis balls- dollar store


• duct tape- I found duct tape sheets at the dollar store and they were just the perfect size.  10 small sheets for $1


• a hose and nozzle


• cheap soap or baby shampoo- The dollar store shampoo I bought was a little too runny.  Dish detergent woks well but depending on the age of your kids, you'll want something that is non-stinging.


• a pool noodle


• a good pair of scissors

Roll out your vapour barrier and cut it in half.  Mine was 4-4.5 ft wide- that just encourages more kids on the slide at once and the potential for tears if not injuries.  You can also cut it to a good length for your yard.  I have enough left to keep us going for a few years.

I stitched a "hem" in the end of my slide.  This creates a pocket for the pool noodle and the reason for this is two fold.  It creates a bumper at the bottom and it gives me a way to roll up the slide when we are done.  You could use duct tape to do this as well.  The bumper works well for little ones but not as well for bigger kids.



At four evenly spaced intervals, on either side of the slide, place a duct tape sheet.  this will keep the plastic from tearing.



Cut a slit in each tennis ball.  The tennis balls will go on top of your pegs to prevent injury.



Peg your slide down with the tennis ball pegs on each of the duct tape patches.  You might be able to forgo the pegging if you have a flat yard but we are on a slope and this would never work without securing the plasic sheet. 

Secure the hose at the top of the slide, using one of the remaining pegs.



Squirt some soap on the slide and turn on the water.  For best results, grab a buddy.





If you are using the slide for while, you may want to check the bottom of the slide.  We ended up with a mudhole.



Have Fun!!!